tech-sheet-12728118
Wiring Diagram Technical Information Side by Side Refrigerator

! WARNING NOTE: Refer to Service Bulletin F-897A-S for complete diagnostics of Ice ‘N Water dispenser control

To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power before Due to a possibility of personal injury or property damage, always contact an authorized technician for servicing unless tests require power. Discharge capacitors through a 10,000-ohm resistor before handling. Wires service or repair of this refrigerator. removed during disassembly must be replaced on correct terminals to ensure proper grounding and polarization. Refer to Service Manual RS1300005 for installation, operating, disassembly, icemaker, testing, and troubleshooting information.

! CAUTION

All safety information must be followed as provided in Service Manual RS1300005.

! WARNING

To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power before servicing unless testing is required. Discharge capacitors through a 10,000 ohm resistor before handling. Wires removed during disassembly must be replaced on correct terminals to ensure proper grounding and polarization.

No-Load Performance, Controls in Normal Position

Kw/24 hr ±0.4 Percent Run Time Cycles/24 hr Refrigerator Center Freezer Compartment ±10% ±25% Compartment Average Food Average Food 65° 90° 110° 65° 90° 110° Temperature ±3°F Temperature ±3°F Ambient °F 65° 90° 110° 65° 90° 110° 24 cu ft 1.3 2.06 2.9 65° 90° 110° -6 26 cu ft 1.3 2.06 2.9 1 36 57 75 30 31 19 34 39 40 -7 -7

37 57 75 34 35 19 33 37 39 -5 -3

Temperature Relationship Test Chart

T-1 Outlet T-2 Inlet T-3 Suction Line Average Total Suction Head Pressure ±3°F ±3°F ±7°F Wattage ±10% ± 5 PSIG Pressure ±2 PSIG

Ambient °F 65° 90° 65° 90° 65° 90° 65° 90° 65° 90° 65° 90° 24 cu ft 26 cu ft -26 -22 -26 -22 74 98 132 143 6″ 0 87 137

-25 -19 -24 -19 72 98 132 146 6″ 0 87 137

Schematic

December 2002 4 12728118 December 2002 1 12728118

Component Specifications Dispenser Operation

! WARNING ! WARNING

To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power before To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power before servicing unless tests require power. Discharge capacitors through a 10,000-ohm resistor before handling. Wires servicing unless tests require power. Discharge capacitors through a 10,000-ohm resistor before handling. Wires removed during disassembly must be replaced on correct terminals to ensure proper grounding and polarization. removed during disassembly must be replaced on correct terminals to ensure proper grounding and polarization.

Component Specifications all parts 210/220 VAC ! CAUTION Compressor run capacitor 115VAC/60HZ unless noted Compressor 15 µfd ± 10% To avoid risk of damaging electronic circuit board. Electro-Static Wrist strap must be worn when replacing Volt …………………………………………….. electronic circuit board. Damper control Capacitance ………………………………… 965 BTUH Freezer temperature control Seconds to dispense 10 oz. water Condenser motor BTUH ………………………………………….. 60 Hz / 168 watts Watt …………………………………………… 19.5 amps± 15% Supply pressure 35 psig 45 psig 55 psig 75 psig Evaporator fan motor Current Lock rotor…………………………. 1.50 amps± 15% 6.0 Current Full load …………………………… 2.79 ohms± 15% Filter model 9.0 8.0 7.0 7.0 Overload/Relay Resistance Run windings ………………. 4.49 ohms± 15% Resistance Start windings ……………… Bypass installed Thermostat (Defrost) Closing temperatures Settings 50.6°F Filter model 11.0 10.0 8.0 Evaporator heater #1……………………………………………….. 42.3°F Defrost timer #4……………………………………………….. 34.1°F New filter installed Auger Motor #7……………………………………………….. Water Valve (primary) Temperatures A minimum supply pressure of 35 psig for water filter units. Minimum pressure Water Valve (secondary) Settings 9.4°F ±3° requirement ensures that water valves close and sufficient water volume is available to fill icemaker. Light switch #1 – out……………………………………….. 0.0°F ±1.5° Proper fill is 140 cc. of water in 7.5 seconds. Failure of water valves to close because of low pressure Light switch / Interlock #4 – out……………………………………….. -4.3°F ±3° Solenoid (Ice Chute) #7 – out……………………………………….. will result in fill-tube freeze-up or dripping at cavity. Clockwise Rotation (facing end opposite shaft) RPM 1100 RPM 8.6 watts±15%@115VAC Watt ……………………………………………. 0.11 amps± 15%@115VAC Current…………………………………………

Rotation (facing end opposite shaft) Clockwise Dispenser Operation RPM…………………………………… 2800 RPM Select WATER, CRUSHED or CUBED mode by pushing the button on the dispenser panel. A green indicator light above Watt……………………………………. 5.9 ±15% watts@115VAC the button indicates the current selection. Note: Fan blade must be fully seated Dispenser Light on shaft to achieve proper airflow. 3.51 amps± 15% Light activates at full power when dispensing ice or water. 142°F ±6° Ult. trip amps @ 158°F (70°C)………… 257°F ±3° Close temperature ………………………. 10 seconds ±5 Open temperature ………………………. 14 amps ±2amps

Short time trip (seconds) ……………….. Short time trip (amps @77°F (25°C) ..

Volt ……………………………………………. 120/240 VAC Table A: Harness 9-pin Connector Configuration Watt …………………………………………… 1000 watts Current………………………………………… 10/5 amps Pin Color Signal Resistance across terminals: Above 45°F ±5° ……………………………. Open 1 GY Ice Door Chute Solenoid Below 15°F ±7°…………………………….. Closed Dispenser Light 115 VAC 2 BR Cubed Volt …………………………………………….. 450 ±5% watts @ 115VAC Crushed Wattage ………………………………………. 3 OR Line Out Resistance…………………………………… 29 ±5% ohms Main Actuator 4 BU Line In

Volt …………………………………………….. 120VAC, 60 HZ 5 RD Neutral Defrost period (minutes)………………… 33±3.6 Defrost cycle (hours) …………………….. 8 6 YL Rotation (facing end opposite shaft) Power to blue and white is clockwise. Power to 7 VT RPM …………………………………………… orange and white is counterclockwise Watts …………………………………………. 17± 3 RPM 8 Watts ………………………………………….. Brown side 35w, Purple side 20w Brown side 35w, Purple side 20w 9 WH

Type…………………………………….. SPST NC NOTE: Refer to Service Bulletin F-897A-S for complete diagnostics of Ice ‘N Water dispenser Volt……………………………………… 125/250 VAC control Current………………………………….. 5/2.5 amps

Type…………………………………….. SPDT NO/NC Volt……………………………………… 125/250 VAC Current………………………………….. 5/2.5 amps Resistance across leads ……………….. 101ohms ± 10%

December 2002 2 12728118 December 2002 3 12728118