tech-sheet-12575029
Wiring Diagram Technical Information Side by Side Refrigerator

! WARNING Due to a possibility of personal injury or property damage, always contact an authorized technician for service or repair of this refrigerator. To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power before servicing unless tests require power. Discharge capacitors through a 10,000-ohm resistor before handling. Wires Refer to Technical Data Sheet for troubleshooting of dispenser included with this product in opposite hinge cover. removed during disassembly must be replaced on correct terminals to ensure proper earthing and polarization. ! WARNING

To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power before servicing unless testing is required. Discharge capacitors through a 10,000 ohm resistor before handling. Wires removed during disassembly must be replaced on correct terminals to ensure proper earthing and polarization.

No-Load Performance, Controls in Preset Factory Position

Kw/24 hr ±0.4 Percent Run Time Cycles/24 hr Refrigerator Center Freezer Compartment 18° 32° 43° ±10% ±25% Average Food Compartment 18° 32° 43° Temperature ±2°C Average Food Temperature ±2°C From Display 18° 32° 43° From Display -18.3 -18.3 -18.3 Ambient °C 18° 32° 43° 18° 32° 43° 22 cu ft -18.3 -18.3 -18.3 26 cu ft 1.14 1.98 3.62 31 54 91 37 32 12 2.2 2.8 2.8

1.3 2.06 2.9 37 57 75 34 35 19 2.2 2.8 3.9

Temperature Relationship Test Chart

Evaporator Evaporator Suction

Outlet Inlet Suction Line Average Total Pressure Head Pressure ±3°C ±3°C ±7°C Wattage ±10% ±2 Bar ± 5 Bar

Ambient °C 18° 32° 18° 32° 18° 32° 18° 32° 18° 32° 18° 32° 22 cu ft 26 cu ft -29.4 -29.4 -29.4 -29.4 20.5 34.4 133 138 .14 0 3.2 4.91

-31.6 -29.4 -31.6 -29.4 22.2 34.4 132 146 .20 0 2.9 4.64

Schematic

April 2002 4 Manufacturing # 12575029 April 2002 1 Manufacturing # 12575029

Component Specifications Adaptive Defrost

! WARNING ! WARNING

To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power before To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power before servicing unless tests require power. Discharge capacitors through a 10,000-ohm resistor before handling. Wires servicing unless tests require power. Discharge capacitors through a 10,000-ohm resistor before handling. Wires removed during disassembly must be replaced on correct terminals to ensure proper earthing and polarization. removed during disassembly must be replaced on correct terminals to ensure proper earthing and polarization.

Part Number Component Specifications all parts The High Voltage board adapts the compressor run time between defrosts to achieve optimum defrost intervals by monitoring the compressor run 230VAC/50HZ unless noted time and length the defrost heater is on. 10958304 Compressor run capacitor 420 VAC After initial power up, defrost intervals are 6 hr. (initial), 6 hr. (minimum), 72 hr. (maximum). Defrost is delayed for 4 min. after the control cycles Volt …………………………………………….. compressor off. 12049719 Compressor Capacitance ……………………………….. 5 µfd ± 10% Optimum defrost is 15 minutes. Each additional minute the defrost thermostat remains closed, 1 hr. is subtracted from the previous defrost interval. Each minute the thermostat opens prior to optimum defrost, it extends the next defrost interval 1 hr. High Voltage board will terminate defrost at 30 12618104 Motorized damper BTUH …………………………………………. 940 BTUH minutes even if defrost thermostat has not opened and will reset the defrost interval to the 6 hr. minimum setting, Watt …………………………………………… 50 Hz / 166 watts A 6 minute delay occurs after defrost thermostat opens before compressor is allowed to run. If defrost thermostat opens within 30 seconds of 12673301 Thermistor Current Lock rotor ………………………… 12.0 amps± 15% beginning of defrost, delay is by passed. Current Full load ………………………….. .79 amps± 15% Six hours of continuous compressor run will initiate a defrost, and defrost interval re-sets to 6 hours. Resistance Run windings………………. 11.4 ohms± 15% Resistance Start windings……………… 18.6 ohms± 15% Power up: If defrost thermostat is open, compressor is powered. If defrost thermostat is closed, defrost is powered. Volt …………………………………………….. 250 VAC Amps …………………………………………. .13A To Force or Terminate defrost: Toggle freezer door light switch 5 times within 6 sec Max ……………………………………………. 43.3°C If defrost terminator is open, a forced defrost will not occur until the defrost terminator closes. Min …………………………………………….. -6.7°C Dispenser Operation Ohms Temperature 2562 K ……………………………………… -17.8°C ±2% Dispenser Operation 82.77 K …………………………………….. 3.3°C±2% 10884508 Condenser motor 35.64 K …………………………………….. 21.1°C±3% The water and ice dispensing functions work independently of each other. To dispense water press the water button, to dispense ice press, the cubed button for cubed ice, press the crushed button for crushed ice. Rotation (facing end opposite shaft) Clockwise Auto Light RPM…………………………………… 1300 RPM Light activates at full power when dispensing ice or water. A sensor activates light at half-power when light level around refrigerator is low. Activate or Watt……………………………………………. 10.7 watts±10%@230VAC deactivate sensor by pushing ON / OFF button located on control façade. Green light above ON / OFF button indicates sensor is active. Current ……………………………………….. 0.06 amps± 15%@230VAC Dispenser Lock Prevents operation of water and ice dispensers. To activate or deactivate lock, press and hold LOCK / UNLOCK button for 3 seconds. Green light above 10449511 Evaporator fan motor Rotation (facing end opposite shaft) Clockwise button indicates dispenser lock. If auger motor or water valves not hooked up or there is an open circuit to either of these components, then the control will RPM…………………………………… 2700 RPM automatically lock the dispenser out. 12555903 Overload/Relay Watt…………………………………… 8.4 ±15% watts@230VAC Automatic Lock Out Note: Fan blade must be fully seated 12601203 Thermostat (Defrost) on shaft to achieve proper airflow. 1.56 amps± 15% Shuts down both ice and water mechanisms of dispenser when either mechanism has run continuously for approximately 3 minutes. To return power to 61°C ±9° dispenser, press and hold DISPENSER LOCK for 3 seconds. Auger motor shuts off automatically after 3 minutes of continuous operation. After about 3 12049803 Evaporator heater Ult. trip amps @ 158°F (70°C) ……….. 120°C ±5° minutes in shut-off state, auger motor resets automatically. Close temperature ……………………… 10 seconds ±5 12620801 LV Board Open temperature………………………. 6.8 amps ±2amps Filter Status Light This feature reminds users to replace water filter after 12 months have passed or after 500 gallons of water are filtered, whichever happens first. Short time trip (seconds)……………….. 240 VAC Short time trip (amps @77°F (25°C).. 450 watts NOTE: Filter status light turns red after 12 months have passed or after 500 gallons of water are dispensed, even if bypass is installed and unit is used 1.87 amps without filter cartridge. Volt ……………………………………………. Watt …………………………………………… Open Green light indicates filter in good condition. Red light indicates filter replacement needed. To turn off filter status light press auto light and water Current ……………………………………….. Closed pushbuttons. Resistance across terminals: 230 VAC Above 7.2°C ±5° ………………………….. 435 ±5% watts @ 230VAC Filter Status Light Reset Below –9.4°C ±7°…………………………. Once filter light turns red, it remains red until reset. To reset filter indicator, press both UNLOCK / LOCK and WATER pushbuttons simultaneously and 29 ±5% ohms hold for 4 seconds. Make sure green light flashes 3 times when indicator resets. Volt …………………………………………….. Wattage………………………………………. Class 2, LV DC Sabbath Mode Resistance ………………………………….. This mode is intended to deactivate power to the LED and dispenser lights, while allowing the controls to remain operational. To activate Sabbath Mode: Volt …………………………………………….. Press and hold both LOCK / UNLOCK and Light ON / OFF buttons simultaneously for 3 to 4 seconds, the LED and dispenser lights will turn off. Dispenser light will not activate during dispensing while in this mode. To deactivate Sabbath Mode: Press and hold both LOCK / UNLOCK and Light 12673101 HV Board Volt…………………………………………….. 230VAC, 50 HZ ON / OFF buttons simultaneously for 3 to 4 seconds. After 3 to 4 seconds the LED and dispenser lights will activate.

10525202 Auger Motor Rotation (facing end opposite shaft) Power to blue and white is clockwise. Power to Hidden Lockout for Upper Keypad orange and white is counterclockwise 12544004 Water Valve (primary) RPM …………………………………………… 17± 3 RPM The purpose of this mode is to prevent tampering with the upper set of dispenser controls. This includes the Display ON / OFF, Max Freeze, Max Cool, 12544104 Water Valve (secondary) Watts …………………………………………. Tan side 15w, Black side 10w Vacation Mode and Temperature Set functions. To activate Hidden Lockout: Press the LOCK / UNLOCK and Display ON / OFF buttons simultaneously for 12466103 Light switch/ Interlock Watts ………………………………………….. Tan side 15w, Black side 10w 3 seconds. To reactivate Hidden Lockout: Press the LOCK / UNLOCK and Display Light ON / OFF buttons simultaneously for 3 seconds. Type…………………………………….. 12466104 Light switch Volt……………………………………… SPDT NC Temperature Conversion Mode Current………………………………….. 250 VAC 12575402 DC Solenoid (Ice Chute) 6 amps This mode is available to change the Temperature Display between Fahrenheit and Celsius. To change temperature reading: Press the display ON / OFF and Freezer Temp Set Increase button simultaneously for 3 seconds. Type…………………………………….. SPST NC Volt……………………………………… 250 VAC Vacation Mode Current………………………………….. 6 amps This key if enabled causes less frequent defrost cycles. This conserves energy. Pressing the Vacation mode key will activate the Vacation mode. Opening Resistance across leads ……………….. 367ohms ± 10% either door or pressing the Vacation key again until LED is not illuminated will deactivate the Vacation mode. Defrost after exiting Vacation mode will occur Voltage to Solenoid 120 VDC across leads according to previous defrost history prior to being put in Vacation mode.

April 2002 2 Manufacturing # 12575029 April 2002 3 Manufacturing # 12575029